Search results

  1. Ricky_rich

    Mariner 200 efi 1992 oil hose?

    Thanks for the information. I just bought this engine and thought it look strange.
  2. Ricky_rich

    Mariner 200 efi 1992 oil hose?

    Is it just for ventilation?
  3. Ricky_rich

    Mariner 200 efi 1992 oil hose?

    Can someone tell me where this hose is supposed to go? As you see it's a T on the oil hose from main tank to small tank on the engine.
  4. Ricky_rich

    Yamaha 225 -89 will not turn around?

    Found the fault today. Screews holding the bearing on the piston rod had come loose on one rod. So the screew went into the crank case wall and stopped the movement. The bearing itself is trash. Lucky the engine was at idle when this happened.
  5. Ricky_rich

    Yamaha 225 -89 will not turn around?

    I was idling the engine home on a hose. Have started if a few times the last week, and thought it run fine every time. Running on pre mixed fuel even though engine have autolube. This is a engine that I bought recently and have not been out on the lake with so far. Suddenly the engine stopped...
  6. Ricky_rich

    1989 Yamaha 225hp extremely bad spark

    I'm sorry I see now that I need a peak voltage adapter to measure the voltage from the coils. Have to get me one of those.
  7. Ricky_rich

    1989 Yamaha 225hp extremely bad spark

    Thanks, this is what I need. My cranking RPM is 220, manual say it should be over 250. First voltage from stator should be minimum 85V, I only get 15V. And next voltage should be minimum 25V, I only get1.5V. A new starter is ordered today. Hopefully that's the issue here.
  8. Ricky_rich

    1989 Yamaha 225hp extremely bad spark

    Have not get it started. But battery is good.
  9. Ricky_rich

    1989 Yamaha 225hp extremely bad spark

    It a 225A ETOL from 1989
  10. Ricky_rich

    1989 Yamaha 225hp extremely bad spark

    I have 12v in on red wire to cdi when I crank the engine. But I understand that it's alot more to it. Can you tell me more about what to measure?
  11. Ricky_rich

    1989 Yamaha 225hp extremely bad spark

    I recently bought this engine. It has been sitting on a boat at the previous owner’s backyard for maybe 10 years and not used. And of course I can not start it. Have new plugs but almost no spark on them. Have only seen a very week (almost invincible) spark on two of the six cylinders. There is...
  12. Ricky_rich

    Yamaha 90 2-stroke air hose?

    Here is the whole head with the hose plugged. I noticed that the colour of the cylinder part don't match head and intake. Someone might have replaced it back in time. There are two hoses going between intake, and one from intake to cylinder 2, should it be four hoses in total?
  13. Ricky_rich

    Yamaha 90 2-stroke air hose?

    Been looking everywhere but I can not find any connection for this small hose. Could you provide a picture maybe?
  14. Ricky_rich

    Yamaha 90 2-stroke air hose?

    I have only run it at home on a hose.
  15. Ricky_rich

    Yamaha 90 2-stroke air hose?

    I have been looking but can't find other end? My motor is from -88. An -89 and newer dont have this connection?
  16. Ricky_rich

    Yamaha 90 2-stroke air hose?

    I recently bought this outboard and started it for the first time yesterday. Runs like crap and air comes out of the little broken hose. Whats wrong here, should it be connected somewhere?
  17. Ricky_rich

    Johnson 40hp 1995 overheating and rough idle?

    I’m having two problems here with this motor, think they might be connected. Problem 1. I cannot get the engine to idle properly, have done the link and sync process. Cleaned the carburetors and make sure there getting fuel. Spark is good on both cylinders. When giving throttle there isn’t...
  18. Ricky_rich

    Mercury 850 no spark on one cylinder?

    I’m having some problems with this motor. First the cables to the trigger was broken. So now I’ve replaced the trigger and put everything back together. But I have no spark on cylinder two? Anyone have an idea how to find the fault? Motor is from 1977 from what I understand.
  19. Ricky_rich

    Johnson Stinger 70 timing?

    I have a compression tester so that's easily done. But the spark test you are talking about, should I get a tool like the one in the picture for that? Or can I let the spark jump to ground?
  20. Ricky_rich

    Johnson Stinger 70 timing?

    I have only checked spark at home on the trailer with a hose, no gear. Guess I have to do it WOT out on the lake before doing anything else. What else should I check aside from the things I've done? Here is the boat, barely 15 feet.
Top