Search results

  1. N

    1992 JOHNSON 150hp TILT/TRIM MOTOR

    Yesterday Strbd Engine's Motor Stopped Operating Leaving The Engine In The "down" Position. How Do I Get To Raise The Engine To Work On Tilt/trim Motor? Thanks.
  2. N

    1992 Johnson 150HP Silver Star OIS Stalling

    I am running 150 twins. Cold Startup is fine, high rpm (1200) idle that comes down to 900-1000 after warmup. Plenty of power, runs smooth thru all rpm range. Problem is after engines have run for a while,are shut down and set for a while,(may be 15minutes or so) the engines start up but will...
  3. N

    1992 Johnson 150HP Silver Star Series

    Can the fuel air mixture be adjusted ? I m being told my outboard is running too lean @ idle.
  4. N

    Twin 1992 150 johnson (60 deg) outboards; one (1) spits at idle and stalls.

    Silver Star Series Outboards. After start the port (counterrotating) engine will spit every few seconds and stall a number of time during intial start/run. When hitting the key primer or putting in gear under load the engine stops spitting. Local mechanic says it's running lean. Can the engine...
  5. N

    Johnson Outboard Lower Unit Removal

    I am about to remove to rebuild a damaged (propeller shaft sheared) lower unit from my 1992 Johnson 150 HP outboard. Is there any special steps to take in removing the lower unit such as sequence of unbolting, shift location before unbolting etc?
  6. N

    Johnson outbord lower unit interchangeability.

    I have a Model # J150EXENC 1992 Johnson 150 HP Silver Star Series 60 degree 25 inch shaft RH turning outboard in need of a lower unit. Can I interchange a Model # J150VXSIG 2001 lower unit to my 1992? It also is a 25 inch shaft but the "V" denotes a special gearcase...???
  7. N

    Amount of Time for Lower Unit Repair

    I would appreciate any response identifying how many hours are involved in removing a lower unit, replacing the propeller shaft, resealing and reinstalling the lower unit on a 1992 Johnson 150 HP v-6 outboard.
  8. N

    Johnson lower unit repair or replacement

    Last Friday I sheared off the propeller shaft and propeller on my Johnson 150hp outboard. I believe the shaft fatigued because I was in 30+ ft of water and no evidence of anything visible that I could have hit. ..still trying to figure it out,. My question is, the marina mechanic says I should...
Top