Search results

  1. T

    2002 115hp EFI on motor fuel filter orange float

    Is the orange float in the on motor fuel filter supposed to be at the bottom of the tall sight bowl? or is it supposed to float up at the bottom of the filter, or some other way? Thank you .
  2. T

    2002 merc 115hp EFI

    Hello, Our 2002 merc 115hp EFI dies when its warmed up, and you shift from neutral into gear. Starts every time when cold, after she warms up and we put it in idle, pull a crab pot, then put in gear she dies. New, fuel, water separators, fuel lines,on engine fuel filters, gear lube, engine oil...
  3. T

    Two stroke oil in a four stroke gas?

    I just asked a guy at a worldwide lube company, can I add a dab of two stroke oil to my four stroke gas so my motor doesn't lean out and burn up. He said yes, lots of guy do it, I then asked him how much per gallon, I can't tell you that,i could lose my job. Has anybody ever heard of doing this...
  4. T

    Shifter cables stretched ?

    Why do you have to buy new shifter and throttle cables because there stretched from being old, can't you just tighten and adjust them? The problem is when we go in forward,then back to neutral, the neutral interlock switch is centered perfect, but then when we go in reverse then back to...
  5. T

    neutral interlock switch

    I hope you two are well This is the third maybe forth time I have centered the NIS, and then again, a long way from home, turn key nothing,take cover off center NIS, make it home. Fellas what do we do? Thank You.
  6. T

    Wiring

    Can we use 14 gauge solid copper wire/Romex for boat wiring ? There is another romex called UF/ Underground Feed it has a stronger cover that's gray. The old stranded 16-18 gauge is corroding and breaking in places along the wire. does conduit help or not. I have a very open mind to all...
  7. T

    Old cowling insulation removed.

    I removed the black rubber insulation that was glued to the motor cover/cowling, because it was raining all over the motor, making a big mess. Should we glue new insulation back on,if so, which kind of insulation material should we use. Thanks.
  8. T

    I cant remove the flywheel, on a 125

    Hello, I have been trying to remove the flywheel on and off for a few weeks now, PB blaster, breaker bar, finally striped a bolt, installed a heli coil, just tried a HF electric impact wrench, no luck. Nothing is broken, should I just leave it alone, until something in there breaks ? I'm a...
  9. T

    When our 125 eats a piston

    I am learning so much so fast,because of everybody that's writes something, a big thank you everybody here, Hey when our Force 125 eats a piston, can I hone it out to .010 over, install a wiseco piston, and get back to crabbing, during our two month summer crabbing season here on Puget Sound...
Top