Search results

  1. N

    Sea King k700 2107a getting too much...air? Carb issues

    About a week ago I tore into my 71' (I believe it's 71) Sea King 7hp outboard to replace the lower end gear grease with fresh. In doing so, I ran into a slew of other issues all of which I have finally managed to fix. (broken roll pins, recoil spring acting up/getting stuck, etc.) However now I...
  2. N

    Sea King/Clinton K700 Repair Roll Pins needed!

    Hello all. I had my Sea King k700 2107a apart yesterday to replace the old sticky grease in the lower gear housing with fresh gear oil instead. I reassembled the housing and quickly found that I couldn't really turn the prop. I pulled the pull cord to see if that would spin it, nothing. Well...
  3. N

    Sea King k700 2107a Propeller

    Does anyone know what propeller size/pitch I need for a Sea King k700 2107a. I have been looking around but am having a hard time finding info. I believe that the prop on it now was a replacement and an incorrect one at that. If it matters at all, the engine is on a 12 foot Jon that is used for...
  4. N

    Need a replacement Walbro LMB-179 Carb - help!

    I have a 70's Montgomery Sea Ward 7hp motor and today my seal kit arrived so that I could replace various seals and gaskets on it. However after getting everything replaced and screwing the needle into the bottom of the float bowl, after very little pressure, SLIP. The inside of the carb is...
  5. N

    In need of a carb for Sea King/Clinton K700 2107A 7HP

    Does anyone know where I can get a replacement carb for this motor? I checked ebay and found one result that I THINK will work but not positive. The carb in that post also looks like it has seen some better days...
  6. N

    Montgomery Ward Sea King 45GG-9015A - Help me get it running!

    Hello all. A couple of months ago we began cleaning out my grand parents basement. In doing so we found an older Sea King. I tried to get it running but so far no luck. I put fresh gas and new plugs but still nothing. Upon getting the top of it opened I figured out my issue. The coil...
  7. N

    1973 Clinton(?) / Sea King k700 2107a questions

    Hello everyone! I just purchased what I believe is a 1973 or 1974 Sea King or as some people are saying, Clinton. I was told the motor runs fine but I already have one problem, I don't have a gas tank. I bought one and bout a fuel line with no ends because I have no idea what ends this motor...
  8. N

    1949 Firestone - Help me get it running!

    Hello guys! My dad has had an old Firestone boat motor sitting in the shed for years now and I finally grabbed it in hopes of getting it running. The motor DOES have compression so we are off on the right foot. I took the carb off and it looked pretty clean. Gas is moving through the line as...
Top