Search results

  1. D

    1990 Sea Nymph GLS 195 floor replacement advice

    Sorry, I found a thread with a similar plan as mine that I will follow for this question. If it turns into more, maybe I will create a full restoration thread in the future.
  2. D

    Fastening choices - floor replacement in aluminum boat.

    Thanks for the quick info ! Following your other link now. I think individually wrapping as you describes would be best. This way, as you said each panel can be wrapped and edges protected. Also, if something happened in one bad spot for some reason, the whole floor wouldn’t need to be pulled up...
  3. D

    1990 Sea Nymph GLS 195 floor replacement advice

    Going to replace the ply wood and floor covering on my aluminum boat. The previous owner already replaced some of the parts and merely stapled carpet on top of plywood without wrapping it or taking the carpet up the gunwhale at all. There will be at least 5 separate sections of plywood that...
  4. D

    Fastening choices - floor replacement in aluminum boat.

    Curious as to what you ended up choosing? I am literally in the same thought process right now as I am starting to replace the plywood floor in my 1990 Sea Nymph GLS 195. I can't decide. Not sure how it was from factory because precious owner had already replaced and literally just stapled...
  5. D

    Help needed-1990 evinrude 70hp carb question

    Thanks for the input racerone. Running 50:1 mix. The VRO was already disabled when I purchased. I will grab my neighbors timing light tomorrow and get back on after that.
  6. D

    Help needed-1990 evinrude 70hp carb question

    120 on all three cylinders
  7. D

    Help needed-1990 evinrude 70hp carb question

    I recently purchased a boat with this 1990 70hp Evinrude e70tles is what is in the title. Looked clean when I bought it, started right up when I purchased it. I took it out and it runs fine wide-open throttle, but it intermittently stalls when I’m at low idol in the no wake zone. I troubleshoot...
  8. D

    1988 Cobia Sunskiff 200 restoration

    Hello to everyone. I’ve watched the site for a long time, but have recently subscribed after I bought this Cobia center console. I purchased this boat for dirt cheap, absolutely understanding at the time just how much work is going to be needed to fix her up. My hopes are to document this...
  9. D

    1984 Chris Craft scorpion 215wa

    Hello everyone! New to the forum and seeking help with any information about a 1984 Chris craft scorpion. I haven’t seen the boat yet, planning on going Saturday. The gentleman did send pictures which I will post. It’s a stern drive and hasn’t been in the water for two years by the sound of it...
Top