Search results

  1. W

    Kill Switch

    I have a '87 50 HP VRO, I want to install a kill switch. I have a kill switch which has 4 posts. Two marked C (coil I think)and two marked M (magneto I think). Some one told a black wire with tan stripe is the wire to splice into. But how do I connect to kill switch?
  2. W

    Trim Tilt Question

    I have a 87 Evinrude 50 HP VRO. When raising the motor it goes pretty quick until it hits a cetain point and then goes really slow, almost struggling. Also when under load (full throttle)the trim motor only goes to a certain point then stops. If you let off throttle, it will go up the rest of...
  3. W

    No water coming out telltales, impellor is OK

    Checked impellor and it is fine. Could it be Thermostats. Where are they located in 87 50 HP Evinrude VRO. Any other things to check. Losing valuable fishing time.
  4. W

    50 HP Evinrude VRO No water

    Nothing coming out the pisser. Stuck air hose in line and blewit out and still no water at pisser. Don't know much about outboards, what could it be, impeller, waterpump. How do I remove lower, where is shift rod nut, pin?
  5. W

    50 HP Evinrude WOT

    What should the WOT RPM's be on a 87 50 HP VRO?
  6. W

    50 HP Evinrude won't go into reverse

    Checked cable and cable seems to be OK. Disconnected cable and pushed lever all the way back on motor and still wouldn't go into reverse. Is there another adjustment that I could check
  7. W

    '87 Evinrude VRO 50 HP Questions

    Removed VRO pump. How do I disable alarm?<br />Burnt up two trim switches ($50 each). Is there a trim switch that can handle the higher amperage of an older motor?<br />How do I check oil level in trim pump?<br />Do not have tether kill switch. Which wire in hareness can I cut into to add kill...
Top