Search results

  1. C

    090 block dipstick tube pressed in?

    This is a 4.3 vortec with aluminum pan.
  2. C

    090 block dipstick tube pressed in?

    Im trying to find the correct dipstick tube for my block i bought a tube off ebay but not sure it is the correct one it does not fit the hole.
  3. C

    Alpha one gen1 water coming from lower shift shaft.

    So then i a okay? Ive just not paid much attention before
  4. C

    Alpha one gen1 water coming from lower shift shaft.

    Nope i installed it
  5. C

    Alpha one gen1 water coming from lower shift shaft.

    Also water is pumping great to the motor.
  6. C

    Alpha one gen1 water coming from lower shift shaft.

    Forgot to mention is does slowdown after a minute of running
  7. C

    Alpha one gen1 water coming from lower shift shaft.

    Never really paid attention before is this normal? The water is coming out lower shift shaft just replaced water pump via manual..
  8. C

    Bought a 5.0 mercury kicker 03

    I have a 19 ft marline open blow 2800 pounds will this trolling motor put me around for fish? Its an 03 5.0 mercury
  9. C

    4.3 mercruiser vortec water in oil

    Alright thank you.
  10. C

    4.3 mercruiser vortec water in oil

    So the level of my oil never changes but milky substance in valve cover and under intake and distributor. But not any lower also mind you i have had a stuck open thermostat so has not been fully warming up is this the possible culprit?
  11. C

    4.3 merc water in #5 cylinder

    Well i clean it up well and installed gaskets yesterday before seeing this reply but i did not use any sealer just on the ends of manifold. I torqued doen to 12
  12. C

    4.3 merc water in #5 cylinder

    Had the heads tested and the checked out fine. Did the head gaskets today. Still trying to figure it out. Is it possible that intake manifold leaks just in cylinder 5?
  13. C

    4.3 merc water in #5 cylinder

    So installed new head gaskets. Followed book by a T still not sure how to test my exhaust manifolds and risers. Also is it possible that intake manifold leaks into only cylinder number 6?
  14. C

    4.3 vortec head torque sequence?

    I need the specs and sequence. Thank you
  15. C

    4.3 merc water in #5 cylinder

    Things i have done so far. Cleaned/filled exhaust manifold with acetone did not detect a leak. Also when i installed riser gaskets i never used a sealant like i should have. I have checked over heads with small mirror and the exhaust port and did not see any cracks or anything.
  16. C

    4.3 merc water in #5 cylinder

    I made a mistake it is cylinder 6 that has the water
  17. C

    4.3 merc water in #5 cylinder

    Not sure this is my problem but how would i find out if this is cracked? There was no water in the other cylinder just number 5.
  18. C

    4.3 merc water in #5 cylinder

    Ive check head gasket and didint see any thing no cracked nothing
  19. C

    4.3 merc water in #5 cylinder

    Can it leak in just one cylinder?
  20. C

    4.3 merc water in #5 cylinder

    Took heads off to check gaskets and for cracks cant seem to find anything this motor was rebuilt last summer including heads i overheated once and instantly shut the motor down.
Top