Search results

  1. Z

    gas in oil

    Thank you for reply but not a fuel injected engine.
  2. Z

    gas in oil

    SN 0T870960 - Bought boat and engine from 2nd owner and don't know how many hours on engine. Was told mostly in Virginia in summer light usage, if you can believe that. Noticed high oil level after purchase. Did a seasonal service and filled oil to top mark. After about a months usage, mostly...
  3. Z

    gas in oil

  4. Z

    gas in oil

    This is about my 2006 4 stroke 90 hp ELPT outboard. Read alot about gas in oil. Some say it is caused by running cool and making oil because gas left in cylinder drains down past rings and causes the increase of oil and smell of gas. It was recommended to first check operation of thermostat...
  5. Z

    Crestliner seat removal

    I am looking to have helm and passenger seats repaired for my 2004 1860 bass boat. My problem is I cannot figure out how to remove them. Any help would be appreciated.
  6. Z

    Tach setting

    Tach is Stratos
  7. Z

    Tach setting

    Choke off, in water and engine warm. Acceleration to get on plan indicates rpm much higher than required.
  8. Z

    Tach setting

    2004 Mercury 90 hp 4 stroke has Stratos tach set for 12 pole. However, tach idles at 2000 rpm and performs OK I just know rpm's are indicating high. Is it possible that the Stratos tach needs to be set at something other than 5 (which is supposed to be 12 poles).
  9. Z

    Tachometer Bad?

    Decided that tach was toast. I purchased a new one on ebay which I am hopeful will work ok. Size is ok and has pulses instead of pole settings. Mine is a 12 pole setting so I assume a 6 pulse will be ok. Thanks for all the feed back.
  10. Z

    Tachometer Bad?

    Any recommendations for a new tach. I need it operating so I can sell the boat.
  11. Z

    Tachometer Bad?

    Tach reads beyond 7000 with key off and jumps slightly towards 7000 when key is turned on. Removing the signal wire made no difference with key on or off tach stayed at beyond 7000
  12. Z

    Tachometer Bad?

    Farina tach needle Is pegged beyond 7000 and will not operate. Is there a way to determine if tach is bad or there is a problem on the sender end?
  13. Z

    Fuel problem

    I found the problem to be a leak in the fuel supply hose connection at the fuel tank. Problem solved with the help of all who responded to my request for assistance. Thank you for your help.
  14. Z

    Fuel problem

    Thank you for reply. Motor ran fine last year and Serial number is 0T646239 and fuel pump rebuild kit was Quicksilver 21-857005A 1
  15. Z

    Fuel problem

    One other item I am curious about, it seems when the engine is cold it runs fine and after running a short period and engine warms up is when the failure starts and I must keep compressing the bulb to keep running.
  16. Z

    Fuel problem

    I wonder why crankcase pressure would change after about 10 minutes of running. Never noticed any engine problems other than lack of fuel to keep engine running.
  17. Z

    Fuel problem

    2003 Mercury 90 hp 2 stroke engine. Engine does not appear to be getting fuel. Engine starts in idle and will accelerate and then appear to be starved for fuel. Squeezing bulb makes engine run OK. I rebuilt the fuel pump and when ran it seemed OK for the first 5 minutes, idled OK and ran at 5000...
Top