Search results

  1. B

    2001 Ocean Pro 175 Tilt and trim.

    Sorry so long for the reply . But it was two of the balls in the cylinder that was not seated properly. Fluid was bypassing.
  2. B

    2001 175 Ocean pro Low Rpms and bogging down .

    So after I picked up a harbor feight compression tester it shows to have 75 lbs. Of compression. I dialed my air compresser in to 90 lbs. And used a rubber tip and shot air into the tester and it read 86 lbs. Am I doing something wrong. I would expect my motor have more problems than bogging...
  3. B

    2001 175 Ocean pro Low Rpms and bogging down .

    Going to pick up a compression tester today . It really never gets shut down . It has been progressing the last few months. Thank you for your reply.
  4. B

    2001 175 Ocean pro Low Rpms and bogging down .

    I have a 2001 175 Johnson last time I took it out . I notice half way through the day that at Low rpms I had to use the choke to keep it running idling around scanning fish spots . And it was spudering and popping when in neutral . At wide open it only run 4800 rpms but normally it would be at...
  5. B

    2001 Ocean Pro 175 Tilt and trim.

    Going to continue today after work . Don't know if I am sucking air in system but I would think it would leak over nite
  6. B

    2001 Ocean Pro 175 Tilt and trim.

    Yes I did .
  7. B

    2001 Ocean Pro 175 Tilt and trim.

    Well pulled tnt motor and oil came gushing out . When I move the tilt rod by hand there could possibly be a little air in the top but if I open the manual release valve and push all cylinders down when I hit the trim down they come up????(Don't think that is supposed to happen). So when I hit up...
  8. B

    2001 Ocean Pro 175 Tilt and trim.

    A So would u say it was air all the time? I don't hear air at all . I have open the reservoir so many times to let air out . I am doing it in my sleep. Lol.
  9. B

    2001 Ocean Pro 175 Tilt and trim.

    Hello all!!!!! Put a new seal kit in my tilt and trim. Put it back on the boat and the trim tabs work kinda. As soon as u let off the up button it fades back down a little . Then when u push the down trim button it just hangs there until u let it go then it fades down. So when u get it all the...
  10. B

    Tilt and trim manual release valve

    Was want to know how to test a manual release valve. Is there a way before i just buy a new one. The o rings where broken when it came out. So I grabbed some out of my o ring kit . Just rebuild tilt and trim with all new gaskets and o rings. The trim works but bleeds down but the tilt won't...
Top