Search results

  1. T

    91 OMC 4.3 ESA Problems

    I am working the microswitch and i also tried moving the "W". Same results. The engine purrs and idles perfectly.
  2. T

    91 OMC 4.3 ESA Problems

    I have a 91 OMC cobra 4.3. When shifting into gear the the system grinds until it goes into gear. The RPM's is set to 800 according to the manual and the ESA doesn't seem to be dropping the RPMS when trying to shift. I pulled the shift interrupter lever and the engine doesn't respond most of the...
  3. T

    91 OMC 4.3 ESA

    I finally got the boat to shift properly and now the ESA system isn’t kicking in at all and causing some minor grinding into gear. I unplugged the connector for the shift interuptor and the over throw switches and the engine doesn’t kill. Would this be a bad ESA Module? Thoughts.
  4. T

    91 Seaswirl 4.3 OMC Cobra Shifter Lever Controls.

    The mounting lug molded onto the cable broke and someone thought it was a good idea to epoxy the mount and use hose clamps to keep the cable from moving. Well moving the lever the clamps shifted and the causing the cable to move in the mount. There was an excess of 1/4" of movement which must...
  5. T

    91 Seaswirl 4.3 OMC Cobra Shifter Lever Controls.

    My throttle cable was still connected and the adjustment was off on the throttle cable when I replaced it. Once I disconnected the throttle cable the shift disk in the controller went back to neutral position. First time working on these things. Learning curve. Now that I have new cables...
  6. T

    91 Seaswirl 4.3 OMC Cobra Shifter Lever Controls.

    The shift cable isn’t even connected to the shift interrupter linkage. The shift disk is just stuck in reverse position with the cable connected or not.
  7. T

    91 Seaswirl 4.3 OMC Cobra Shifter Lever Controls.

    I have a 91 Seaswirl with a 4.3 Cobra. I'm changing the shifter Cable from the lever to the engine and to do that I had to put the lever in reverse to access the lever set screw and remove the lever to remove the assembly. Once i put the new cable on, mounted everything back to the panel, and...
Top