Search results

  1. J

    2006 HPDI Prop Question

    4500-5500 is what is recommended
  2. J

    2006 HPDI Prop Question

    OEM says do not exceed 6000. Rev limiter is at 6200
  3. J

    2006 HPDI Prop Question

    I am currently running a 26 Pitch prop on my ZX200 Skeeter with a 200HP HPDI. The boat runs 61MPH at WOT fully loaded turning 5400 RPM. My buddy has the exact same boat and motor and runs 67-68 with a 25 Pitch prop. I have a Suzuki 27 Pitch prop that fits my HPDI. I can get the 67 MPH but my...
  4. J

    2006 VZ200TLR HPDI Interface Cable for Lowrance unit

    I covered my Tach with my Lowrance graph. I want to hook up my HPDI to my Lowrance HDS 12 Gen 2 graph so I can see my RPMs and Engine temperature. Do I only need a Interface cable to run from the HPDI to the graph or will I also need the NMEA 2000 kit. Wasn't sure if I needed both or if just the...
  5. J

    VST Pump O Ring

    2006 200hp VX200TLR There is a small O Ring at the top portion of the VST pump. Mine was damaged/pinched so I need to replace it. My question is: Does it stay on the shaft just above the sleeve or is it to go in the hole and compress when I push the pump into the fuel tube. Neither way seems to...
  6. J

    HPDI Medium Pressure Fuel Filter

    Thanks Boscoe. Mine is mounted in the correct direction. Not sure what I was thinking. I was at work when I sent my post. When I got home I checked again and it was opposite of what I thought.
  7. J

    HPDI Medium Pressure Fuel Filter

    Im trying to see if it was installed incorrectly by the group that did my power head. Currently it has the special fitting towards the VST and the regular end facing the high pressure pump. My engine acts like it has a fuel restriction and im wondering if this could be it before I take it off...
  8. J

    HPDI Medium Pressure Fuel Filter

    2006 HPDI VZ200TLR. This is the filter between the VST tank and High Pressure Fuel Pump. My question is: Is this filter directional. You have the one end that requires the special tool for removing the fitting and the other end just takes the rubber line with a special clamp. Can this filter be...
Top