I have a selco repair manual,but it don't have compression specs.,I know if they are all the same its ok,but I would like to know,what the specs are,thank you
Motor runs,is firing on all cylinders,has new coils,plugs and wires,but it pops when running,I think its the same cylinder,if you rev real high,popping seems to stop,any ideas,I have Selco repair manual,have checked all wiring,stumped
I've got fuel to carbs,carbs are clean,hoses are good,if I spray gas in carb,will run,short time,it will pop like shotgun going off,Oh and have replaced coils,stator,does it hirt anything,not having jet pump installed
i have 95,60hp.mariner,have replaced stator,switchbox,plugs,wires,cleaned carbs,still takes long time to plane,you can here a cylinder kicking in and out,then will kick in and run great,could this be a bad coil?,and how can i test this?
Just replaced switch box on 95,60hp.mariner,has an extra black/w yellow wire,female connector,ever other wire used,and runs much higher idle,anything to worry about?
95,60hp,jet45 mariner,run great until you want get on plane,it boggs at first full throtle,then you can here cylinder kicking on and off,then in time willl come on and run great,its worse with two people,has new stator ,new fuel line,plugs,carbs been cleaned
