Search results

  1. D

    Convert 14ft aluminum closed bow to open

    I plan on redoing the transom aswell it's pretty rotten
  2. D

    Convert 14ft aluminum closed bow to open

    It has 2 bench seats I'll get some pictures tomorrow not sure if there riveted to the sides though. It was a Peterborough that's all I know because u can see it faintly on the side
  3. D

    Convert 14ft aluminum closed bow to open

    Hey I just picked up this 14 ft aluminum boat for cheap I'm lookin to take off the closed bow to open it up I was wondering if this would cause issues. Boat has a 9.9hp and want to use it mostly for fishing smaller lakes.
  4. D

    10r77a rich lean adjust

    #2 on that diagram the propeller shaft seals I found some now though
  5. D

    10r77a rich lean adjust

    Gear lube was about 1/4 water when I checked flushed it out with gear oil until seals come to try and prevent corrosion. Everywhere I look for parts say unavailable for my year would newer seals and such work on a older model?
  6. D

    10r77a rich lean adjust

    Got it all figured out runs great now but now oil coming from prop so need to change propshaft seals :( hard to find parts for this oldie haha
  7. D

    10r77a rich lean adjust

    So update found what's causing the random miss. One of the coil packs has a small crack and was intermittently losing spark to ground
  8. D

    10r77a rich lean adjust

    How would I do the sync?
  9. D

    10r77a rich lean adjust

    OK I got idle set nicely but now under throttle it will miss randomly every few seconds. New plugs good spark on both plugs, compression is around 120 both cylinders, took carb apart and cleaned again. It will run great for 10-15 seconds then a hard miss and run great again over and over
  10. D

    10r77a rich lean adjust

    First outboard after I get it warm do I go leaner until it coughs and then turn it richer 1/4 turn or do I go richer? Or do I just play around until it's highest rpm
  11. D

    10r77a rich lean adjust

    Hey I recently got a 1977 9.9 johnson carb was gummed up so I took it apart and cleaned I didn't take not of the turns the rich and lean knob was at. Does anyone know how many turns from seated it should be ?
Top