Search results

  1. D

    Oil Sensor AND the ECM?

    Can anyone shed a little knowledge on this? My 1998 175 has been sitting in the garage unused for about 5 weeks. Upon starting it, the oil beeper started beeping immediately. I have gone through several tests. The only one I have not completed due to time is the voltage at the coil/green wire...
  2. D

    Flywheel Magnets (six of them)

    I looked at all of the posts I could find about flywheel magnets, but have not seen anything about ALL of the magnets coming loose anywhere. I have a 1998 V6 175 Sportjet that I was hearing an odd noise from. Turns out the flywheel is rusty on the underside and the magnets were loose. I have...
  3. D

    1998 175 Oil Warning Help

    I have a 1998 175 Sportjet with a factory reman powerhead / sticker dated 2000. I have not used the boat for over a month. Last time I took it out, the oil beeper went off one time. The oil was little low and I topped it off. No more warning beepers. Now, 5 weeks or so later, I have the boat...
  4. D

    1998 Mercury 175 Sport Jet kill circuit

    I recently purchased a clean, low time 1998 Sea Rayder with 175 Merc Sport Jet. This is my second Sea Rayder. The first one was a 120. On the older boat, if I turned off the key switch, it would kill the engine, just as if I used the on-dash rocker switch that starts and stops the motor. On this...
  5. D

    94 115 Mariner stopped dead in its tracks

    This motor has run flawlessly all summer and fall. Yesterday, while trolling, it stopped running just as if I had reached over and turned off the switch. No warning or alarms. It had to be towed in. Looked at it today. It will pop and spit a little like it is way out of time, and started once...
  6. D

    Evinrude Cowl Decals

    Evinrude Cowl Decals I need some help on locating a source for replacement cowling decals for my 1994 200hp Ocean Pro Evinrude. I have searched many places online, but have not come up with anything definate. The OEM decals are no longer available.
  7. D

    1994 200hp loads up, runs rough

    My 1994 200 seems to be running too rich. On any hole shot from a stop, it takes a few seconds for it to clean up and run ok. The odd thing about this is that one day, while trying to figure out what is wrong, I happened to put it in the water without the airbox on. What a difference that makes...
  8. D

    94 200 Ev. headgaskets

    I had to have one cylinder bored out due to the piston ring locater pin coming loose. I purchased a non-oem gasket set. The head gaskets do not have nearly the same amount of water circulation holes in them as the ones I removed. The supplier claims this is not a problem. Does anyone have any input?
Top