Search results

  1. J

    2005 50hp 2stroke mercury: replaced oil tank

    I replaced the oil tank on my 50hp merc. Am i supposed to bleed the lines between the oil pump and tank. If so how do you do it? Any help would be awesome. I would like to go gator hunting tomorrow and not run into any preventive problems. i see one pin hole bubble thats it so far. All help is...
  2. J

    05 50hp mecury 2 stroke bogs down, wont idle

    SO i tested the new motor i bought it will start first time but then die right after. Then i try to restart it it will not start unless i high idle it. Starts but well not idle. So i give it a little gas then put it in fwd. Runs fine at about 2500rmp then bogs downs at high rpm but will some...
  3. J

    2 stroke oil? 50hp Mecury 2005

    This is my first oil injected motor i was wondering what kind of 2 stroke oil i should use? Should I use tw3 2 stroke oil? Thanks for all the help Jon
  4. J

    78 evinrude 35hp + postive wire

    My wire has a short somewhere and need a replacement. What gauge is it? So i can replace it. Also if you know a good DIY way let me know please!
  5. J

    78 evinrude lower unit will this work 79

    my 78 evinrude lower unit is pretty much shot(model 35853r) . Will this 79 work? (model number 35953r) I have no clue how to research it to find out thanks.
  6. J

    How do i add a fuel gauge

    I just bought a 20ft jon boat with a custom built gas tank. Well it has no gas gauge or a spot to put one in at. I can not remove the tank as it is welded in place. How can i add something to tell me how much is in there?
  7. J

    gamefisher 15hp

    not spitting water checked the impeller looks good and you tell me where the water hose is to se if anything blocked? would i have to lower the lower unit again?
  8. J

    15hp gamefisher leaking gear oil from water intake

    Well i took my boat and motor out for the first time since i bought it no leaks! But my motor seems to have problems. Running fine shuts of after about 15 mins. i have determined i need a new impeller i think that whats its called so it wont over heat. this isnt my exact motor but i have 2...
  9. J

    ?johnson 6hp wont start been sitting for 1 yr. 1970s?

    No sure the yr its a 50/50 mix pull start. I try to pull start it and it will not start. What should i check for? i am new to this so plase help, I guess i would be stupid in these catorgory
Top