Search results

  1. S

    1979 mercury 7.5 pull start assembly

    Can someone go over the assembly procedure for the whole pull start. 7.5 horse, 1979. Rope broke and I took it apart to replace the rope and the pawls/washers fell out and I want to make sure i put it back together correctly. Thanks
  2. S

    1970 johnson 60 carb cleaning steps

    Will someone please go over every step in graphic detail for me. 1970 johnson 60 horse 3 cylinder electric shift. also what is the correct gear lube for this motor?
  3. S

    wrong flywheel?

    i just noticed that the flywheel on my 1970 johnson 60 inline 3 says that it 1969 V4. um...is this a problem? engine idles well but slowly loses power and then surges.
  4. S

    where is my tell tale

    1970 johnson 60 HP where is the tell tale i am told that most of the water comes out of the prop?
  5. S

    engine loses power after short run

    1970 johnson 60 electric shift it will run fine for a short while and then it will slowly lose power. , then it will surge like it is wanting get going.IF i idle for a little bit it will run well for a short while and then slow down again. carbs are clean and i beleive just rebuilt...
  6. S

    fuel pump for 1970 johnson 60 electric shift

    can't seem to figure out what fuel pump i need. anyone know of a model number or an aftermarket pump that will work?
  7. S

    engine won't crank over

    1970 johnson 60 hp. took it out for the first time today, engine cranked over for a second and then it stopped and won't turn over(makes no noise at all). i have power to the engine because i can here the choke when i hit the switch. I am guessing it is the starter or solenoid. help me out...
  8. S

    prop won't spin on new minn kota

    prop won't spin but i can turn the head from side to side! it's a 40 LB minnkota edge bow mount foot control. I'm using 1 battery, could it possibly be a 24 V so i would need two batteries? anyone have any ideas?
  9. S

    stupid question about steering

    hey guys, this is pretty stupid but, is there a special bolt i need to attach my steering linkage to my outboard. I replaced an old pulley system with rotary, and when i bought the boat nothing was attached (can't find original equipment). Is there a steering arm of some sort or do i bolt the...
  10. S

    i/o steering for outboard?

    can i use a steering system from a searay (15 ft cable) on my outboard. it would be mounted on a 16 foot fishing boat. i beleive that it is a rack and pinion but im not sure.
  11. S

    1970 evinrude 60 HP won't shift

    hey i have 1970 evinrude 60 horse electric shift that will not shift. engine runs and it looks to be in great condition. I was told by the former owner that it was an electrical problem in the lower unit? is this the shift solenoids or could this be in the control box?
Top