MuleyQuest
Recruit
- Joined
- Apr 24, 2009
- Messages
- 4
I am trying to get this motor going again after sitting in storage for last 35 yrs. I replaced the coils, set the points gap, replaced a bad plug wire, cleaned the carb, replaced the impeller, changed lower unit oil. All the normal stuff. I still can't get it to idle and run at low speeds. My compression is 60lbs on both cylinders. I have not tryed any decarb yet since I have not been able to run other than in a garbage can of water so far. Is this way to low for compression? I thought it should at least run fair since both cylinders matched on compression. Maybe this should be turned into a boat anchor? I hope it is not a lost cause. By the way, I am new to this forum and looking forward to being a part of it. Thanks in advance for your help.
MuleyQuest.
MuleyQuest.