Hi,
I followed several threads/instructions on adjusting the low idle speed which say to start by closing, (not too tight), the low idle screw then bringing it out 1 /1/2 turns.... On my motor it only runs if I bring it out 3/4 turn and runs best at 1/2 which seems not right. I took the carb apart and cleaned and replaced the float, seat and needle valve and removed the little freeze and clean the three little passages. I'm guessing that this may be caused from something other than the carb but not sure at this point. Any ideas greatly appreciated.
Thank You
I followed several threads/instructions on adjusting the low idle speed which say to start by closing, (not too tight), the low idle screw then bringing it out 1 /1/2 turns.... On my motor it only runs if I bring it out 3/4 turn and runs best at 1/2 which seems not right. I took the carb apart and cleaned and replaced the float, seat and needle valve and removed the little freeze and clean the three little passages. I'm guessing that this may be caused from something other than the carb but not sure at this point. Any ideas greatly appreciated.
Thank You