1971 Pony 16' ski boat - refit and refloat

gomopar440

Petty Officer 1st Class
Joined
Nov 27, 2007
Messages
281
As I mentioned in my Dillon Laker thread, I recently picked up a 1971 Pony 16' ski boat. It came just as pictured below with the trailer and without the motor and controls. The Laker project is getting mothballed for a while since I'll be using the '84 Mercury 115 on the Pony hull now instead. I'm going to try hanging the 115 on the transom today and then clearing out the tent the Laker is in so I can move the Pony in there.

I ordered a steering wheel and adapter for it already and once that gets here I'll check the existing steering rack and cable for excessive play.

The controls will need a downward extension to the inside of the side rail in order to mount it to the hull. As it sits now, the top of the control box pokes over the top of the gunwhale with the available space on the inside of the gunwhale. The control cables appear to be a little long for this hull, but not enough that I won't be able to use them for a while.

For gauges, I'm leaning towards the Faria Coral series of gauges like this one. I'll most likely use an 80MPH GPS speedometer since the previous owner reported this boat would do 60-65 with his 1970's era Merc 115.

The fuel tank, battery and wiring choices will be next up after I get a chance to take a better look at the available space inside the hull. Whichever way I go, I'm going to be keeping it simple for now to give me the best possible chance to get this boat on the water this summer.
 

Attachments

  • 00Y0Y_loI4eUwWGc5_1200x900.jpg
    00Y0Y_loI4eUwWGc5_1200x900.jpg
    48.8 KB · Views: 0
  • 01313_fHcxDxXCyj8_1200x900.jpg
    01313_fHcxDxXCyj8_1200x900.jpg
    46 KB · Views: 0
  • 00v0v_atAYYwO6JcA_1200x900.jpg
    00v0v_atAYYwO6JcA_1200x900.jpg
    36.1 KB · Views: 0
Top