1976 arrow glass Cheetah HELP

[enrecia]

I need a wiring diagram for a 1976 cheetah i have looked everywhere can some 1 help me find one or post a link to 1 please i really need it badly

 

[flargin]

Re: 1976 arrow glass Cheetah HELP

Unless someone has one, you will be out of luck. THey normally don't have boat specific wiring diagrams.

If you have a specific need you can get great answers, just ask.

If you are looking at re-wiring your boat, take a look at the stickies there are a couple that will show you basic wiring.

 

[enrecia]

Re: 1976 arrow glass Cheetah HELP

well i bought the boat and there are all kinds of wiring problems from the owners before me. at first i thought it was the solenoids so i put all brand new 1s on it and all i am gettin from them is clicking the motor tilt or the power trim are not moving at all just clickin when i hit the switches so the only thing i could think is bad wiring wat do you think

 

[flargin]

Re: 1976 arrow glass Cheetah HELP

well i bought the boat and there are all kinds of wiring problems from the owners before me.

Ultimately it is a good thing to rip out the bad wire and make sure there are only useful wires. it is not easy to do, but you can get control of the wires.

at first i thought it was the solenoids so i put all brand new 1s on it and all i am gettin from them is clicking the motor tilt or the power trim are not moving at all just clickin when i hit the switches so the only thing i could think is bad wiring wat do you think

Could be bad wiring, but since you have a click something is getting there. First I would check your battery... check the voltage as you try to run the trims, if the voltage drops quickly, you likely have a bad battery... take it to an auto part store for checking.

Depending on the type of motor, you can find manuals, and you can try to run the motors more directly, this will help you determine if it is a bad connection in the wiring.

to resolve wiring connections. find every connection, from battery to every switch and fuse, and check for good connection. Sand and use dielectric grease as needed.