my power tnt is not working properly,it works just as supposed to in the up possition but when i go to tilt motor down the TNT motor runs but the motor free falls untill it reaches the trim part then it trims as its supposed to.TNT motor is new as of last summer.i have tried everything i know to try...
i cycle the TNT up and down 4-5 times as specified then check and add fluid if needed,when i remove the fill screw to check fluid level it releases air and i usually get some real foamy fluid leaking out,like its not self bleeding.does anyone know what i should look at to correct this problem,thanks in advance!!
i cycle the TNT up and down 4-5 times as specified then check and add fluid if needed,when i remove the fill screw to check fluid level it releases air and i usually get some real foamy fluid leaking out,like its not self bleeding.does anyone know what i should look at to correct this problem,thanks in advance!!