My Mariner 150 has been acting up the last two trips out. Today I decided to tear into it and see if I could find the problem. The motor has dropped off perfomance, will not plane out easily, and lost about 800 rpm at the top end. I started by checking the plugs, the #1 plug, (top right) appeared some what black compared to the others, I hooked up my muffs, and check for spark. No spark on that plug. I then swapped the coil pack input between 1 and 3 packs. Now plug one fires but 3 don't. Not a coil pack problem. I next went back to the switch box (figures...#1 is on the inside switch box) and swap outputs signals between 1 and 3. Now plug 1 fires, but 3 does not. Bad Switch box? I go and get a new switch box, install it, and now all the cylinders off that switch box are not firing. It did seem to work for a short time, but would cut out at any rpm above 3k, but now I have no spark on any plug coming from that switch box. I decide to install the old switch box back in, now all cylinders, including #1 are firing. Do I have one flakey and one bad switch box?
Any help would be greatly appreciated.
Any help would be greatly appreciated.