I have a 50 Hp force motor I had just bought and it has spark on cylinder 1, so I went ahead and ohmed out the trigger and saw my cylinder 1 trigger was reading about 46.5 ohms. I went ahead and bought a replacement from eBay and tested it and got 48.5 on both, and after installing it I still had no spark so I checked the ohms and it it read 43 ohms on cylinder 1 but when I disconnected it from the motor it goes back up to 48.5 ohms. I went ahead and pulled my coil off and ohmed it out and I had resistance from the the end of the plug wire to the brown and blue wires where as my other coil did not do that I was wondering if the coil is messed up and causing my lack of spark to the cylinder and if so is there a place to go to get decently cheap parts for the motor as most things I have seen are very pricey.