1989 force 125 tirm and tilt ram

[ckb93]

I have a 89 force 125 the tilt ram where the line screws in broke....can the line screw in/band around the ram be replaced and if so where can I find the parts?

 

[hall832]

Re: 1989 force 125 tirm and tilt ram

send pics if you can

 

[pnwboat]

Re: 1989 force 125 tirm and tilt ram

Item #7 in the diagram below.

Mercury, Mercruiser, Force, etc. - PARTS BREAKDOWN TILT CYLINDER, TRIM CYLINDER, MOTOR & PUMP - FORCE 1989 125 H.P. "B" MODELS

 

[ckb93]

Re: 1989 force 125 tirm and tilt ram

Thank to both of you for responding. Commander, #7 looks like what I need.....will order tomorrow.....Thanks again

 

[Jiggz]

Re: 1989 force 125 tirm and tilt ram

I replaced mine not too long ago. Although basically all I needed was just the female brass fitting where the tube fitting screws in. The band kit is just way too expensive but at the time was the only option I got. Come to find out you can actually find the same fitting at some hardware stores which costs a lot less. Just make sure if you decide to look just for the female fitting you take the old one with you. Otherwise you can just order the band kit.

 

[RRitt]

Re: 1989 force 125 tirm and tilt ram

if dealer can not order, then you can make from 1" x 1/32 x 12" piece of stainless available from most local hardware stores