Hi Guys
Lift the deck recently and had to cut the fuel guage wire at the tank. Now that we have put the deck back on , we cannot seem to find the other section of the wire. I think its a green, black and red wire. would such a wire be coming from one of the yamaha multimeter ?
also for the purpose of re mounting engine and starting , I remember pulling two cables from the starter , . Also there is a small white rectangular looking connector above that that we pulled out. another connector with four wires and the loom cable. The VRO system was disconnected years ago. I take it that as long as these were not cut during the process then I should be able to remount the motor and start. The accessories wires are in a complete mess and I am going to need an electrician for that.
appreciate it.
Lift the deck recently and had to cut the fuel guage wire at the tank. Now that we have put the deck back on , we cannot seem to find the other section of the wire. I think its a green, black and red wire. would such a wire be coming from one of the yamaha multimeter ?
also for the purpose of re mounting engine and starting , I remember pulling two cables from the starter , . Also there is a small white rectangular looking connector above that that we pulled out. another connector with four wires and the loom cable. The VRO system was disconnected years ago. I take it that as long as these were not cut during the process then I should be able to remount the motor and start. The accessories wires are in a complete mess and I am going to need an electrician for that.
appreciate it.