Hello all, I did a bad thing to my force 120, I am switching all me electrical from a 1994 (?) 120 force to a 1995 120 and could not get the flewheel off, I used a puller, impact gun, propane bottle then a propane torch which did it. My problem now is I put to much heat on the center magnet and destroyed it, now I have another flywheel off the 1994 that has a bigger shaft hole but the magnet is the same size, can I remove it and, using the keyway as an alignment to, put it on my 1995 flywheel? I am planning to use the maginets and epoxy them on also? I need to know just how I can remove the center magnet. again my 1994 (?) flywheel will not fit the 1995. can anyone point me in the right direction? Thank you, Russell
