1996 impeller replacement question

[jeepinjz]

Anything i should know mine would spray alittle water and air out then sometimes it would be okay so I replaced it took out spray good and hard for one day then the next started to do the same thing a light sparay of water and air then when i fired it up to come in from the sand bar nothing got hook up the hose seem to be coming out good and the hose up top but noice it was coming out were the shifter shaft was and not out the back mid way up on the motor were the exhaust was coming and did before any ideals of what I need to do or what I did wrong Thanks

 

[jeepinjz]

Re: 1996 impeller replacement question

First off should water come out of the three square hole half way up the motor in the rear.It use to but not know.I removed the LU and looked at it last night just to check the installation of the new impeller looks good reinstalled.I have water coming out the pee hole and the center of the prop. which I should at start up right?I also have water coming out were the shifter shaft is on the LU is that correct.And last but not least I don't have anything coming out of the three holes mid way down the rear of the motor and I did before.any help would be great don't want to hurt the motor.Its seems to have been fine but started pumping less water out the pee hole so I changed out the impeller and want to check it now before hitting the water

 

[1fast6]

Re: 1996 impeller replacement question

did you silicone the plate between the exhaust and the pump housing? When the boat is in the water, is your engine trimmed enough so it's not cavitating? Do you have a pressure gauge?

 

[jeepinjz]

Re: 1996 impeller replacement question

did you silicone the plate between the exhaust and the pump housing? When the boat is in the water, is your engine trimmed enough so it's not cavitating? Do you have a pressure gauge?

I did not put any silicone on thew bottom of the plate just on the two sides abot 1 in. long could that be why its coming out around the shifter shaft on the LU.No on the pressure gauge.Not sure of what your asking on the trim question its on the trialer right now.
Thanks

 

[jeepinjz]

Re: 1996 impeller replacement question

I did not put any silicone on thew bottom of the plate just on the two sides abot 1 in. long could that be why its coming out around the shifter shaft on the LU.No on the pressure gauge.Not sure of what your asking on the trim question its on the trialer right now.
Thanks

Talked to the dealer and they said that coming out around the shift shaft on the LU it nornal I'm not buying that anyone know.And as far the the three little oval hoses thay said it will spray alittle out there after the thermo stat opens?

 

[Wingedwheel]

Re: 1996 impeller replacement question

Did you make sure you installed the pick-up tube correctly?

 

[jeepinjz]

Re: 1996 impeller replacement question

I pulled it back off to make sure I put it on the LU then put back together so I'm thinking it should be okay.

 

[Wingedwheel]

Re: 1996 impeller replacement question

What engine is this? Do you have an exhaust boot inside the LU.

 

[jeepinjz]

Re: 1996 impeller replacement question

What engine is this? Do you have an exhaust boot inside the LU.

Its a 1996 serial #og422422 exhaust were would that be?

 

[jeepinjz]

Re: 1996 impeller replacement question

The dealer told to replace the shifter shaft seal that should not have water coming out there/If anything it would be oil right?