Captn Dave
Petty Officer 2nd Class
- Joined
- Dec 5, 2001
- Messages
- 176
This is a carbed motor.
Runs good at home. Go to put it in the water, starts fine, then sometimes it will stall. The last time it stalled several times, then ran okay and started okay for the trip home.
I read about a test you can do for the fuel pumps but I can't find it. Something about loosening the bolts on the fuel pump and then squeezing the primer bulb and looking for a gas leak. There are, I believe, 4-6 philips head screws and 2 hex head screws.
Which screws do I loosen?
Do you do both pumps at the same time?
Also are there any other things I should check?
Runs good at home. Go to put it in the water, starts fine, then sometimes it will stall. The last time it stalled several times, then ran okay and started okay for the trip home.
I read about a test you can do for the fuel pumps but I can't find it. Something about loosening the bolts on the fuel pump and then squeezing the primer bulb and looking for a gas leak. There are, I believe, 4-6 philips head screws and 2 hex head screws.
Which screws do I loosen?
Do you do both pumps at the same time?
Also are there any other things I should check?