I am wanting to install the factory tilt/trim assembly onto my long shaft 25hp and I am wondering if it is even worth the money and time, or if anyone has went that route. Basically I would replace the hydraulic-assist ram on my current motor with the tilt/trim assembly from a 40-50hp motor, install the wiring harness, and the switch.
I'm fairly new to the boating community and am rather ignorant, but on a lengthy search on the interwebs I find that most people want $600-$900 for that assembly with motor and about $100 for the wiring.
Is this a popular enough item that I can find it used if I use the proper keywords? Should I just get the CMC tilt setup?
Thanks guys,
Jesse
I'm fairly new to the boating community and am rather ignorant, but on a lengthy search on the interwebs I find that most people want $600-$900 for that assembly with motor and about $100 for the wiring.
Is this a popular enough item that I can find it used if I use the proper keywords? Should I just get the CMC tilt setup?
Thanks guys,
Jesse