270 outdrive tilt control box

[kgrant341]

Does anyone know how the tilt control box is mounted on the top of the tilt drive on a aq125b/270 I don't see a part on the diagram for mounting it... I think it might be a wedge that the bolt goes through but I have no clue if some one could post a picture of how its mounted or the part I think I can make it myself

 

[captmello]

Re: 270 outdrive tilt control box

Welcome!

#23,24,24a (two of each) hold the box on.

http://www.volvopentastore.com/Mechanical-Lifting-Device-Aq-Drive-Unit-270-275a/dm/*******.001748332--session_id.102005399--store_id.366--view_id.786319

Do not overtighten, just enough to keep the box from moving up and down. The box will still spin freely on the tilt mech.

 

[74bayliner]

Re: 270 outdrive tilt control box

this might help. I made this for another Iboater who had the same question. seemed to help him.

 

[SteveMcD]

Re: 270 outdrive tilt control box

My 280 tilter is held on by two #10 by 3" screws and nuts. There is a ring on the shaft that the nuts engage at the bottom that hold it in place. I do saltwater, so I got stainless steel screws and nylock nuts.