69 115 hp johnson elecshift

[huntertn]

the motor is great and its its running fine..so I bought an trim unit..only it don;t have the holes on the foot to use..and I cann't seem to get it mounted right..cann't find any pictures that show it mounted???? I can rig it to go around the foot somehow..but sure as heck I want that base clamped tight to the transom

 

[huntertn]

Re: 69 115 hp johnson elecshift

and yea, I have a manuel, but it doesn;t show that part of it..

 

[alden135]

Re: 69 115 hp johnson elecshift

What kind of unit did you buy? Did you get an old vintage tilt only set up, a newer T&T, or a cnc aftermarket?

 

[emdsapmgr]

Re: 69 115 hp johnson elecshift

The factory power tilt/trim units from about 1973-1976 may fit on your engine. Not sure that the 69's have the holes drilled in the swivel bracket to accept the lift bracket. You may be able to layout the brackets and drill the holes. Could get to be quite involved if you have to take the midsection off the stern bracket assy. in order to drill the holes. A picture or better description of your unit would help.

 

[R.Johnson]

Re: 69 115 hp johnson elecshift

Your engine use's seperate transom bracket's. If you are talking about a OMC tilt & trim it won't fit without changing the whole swivel bracket, and clamp assembly.