I just installed a new impeller as per the service manual and the posts on this site. After I cranked it up, I am only getting a small "spit" of water out of the top. I have dropped the LU 3 times to make sure the impeller was installed right and that the "chimney" was lined up. What am I missing? Is this correct? The local dealer says that it should be a constant stream coming out of the top. They also says it will spit until the engine is warm and then it will go constant. but I am scared to let it run for more than 1 minute to wait and see!
Please help!
Chris
Please help!
Chris