Alignment tool # C-91-32555, how long and where to buy?

1

1965GTFB

Cadet
Joined
Jul 1, 2010
Messages
14
Any one out there know the length of the engine alignment tool that goes in teh slots on the back of the engine and on the inside of the transom? It is part # C-91-32555 (pic below)according to the original engine installation manual that I have. Tool does not seem to be available any longer. Nedd to check this ASAP. This is on a 1967 120
Thanks
DSCN2302.jpg
 
Last edited:
Bondo

Bondo

Moderator
Staff member
Joined
Apr 17, 2002
Messages
71,148
Re: Alignment tool # C-91-32555, how long and where to buy?

Ayuh,... Whatcha workin' on,..?? That don't look like a Mercruiser...
 
1

1965GTFB

Cadet
Joined
Jul 1, 2010
Messages
14
Re: Alignment tool # C-91-32555, how long and where to buy?

Bond-o said:
Ayuh,... Whatcha workin' on,..?? That don't look like a Mercruiser...
Click to expand...

It's a 1967 MerCruiser 120. That pic is from the original engine installation guide. One family boat.
 
Don S

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Alignment tool # C-91-32555, how long and where to buy?

I would like to know how it works, and what it does. From just a few words I found on it, I think that rod was how they tried to align the early drives, then they came up with the alignment bar used today.
 
J

Jerryh3

Petty Officer 1st Class
Joined
Sep 21, 2010
Messages
325
Re: Alignment tool # C-91-32555, how long and where to buy?

It looks like it's just used to set the fore/aft position. I can't see how it can offer any real alignment.
 
You must log in or register to reply here.
Top