Faucet connection problem.

[Mark42]

I'm installing a new faucet that has two copper 3/8" lines for the water supply. The problem is the water supply valves are about a foot farther away than the copper lines will reach. I found a brass connector that takes 3/8" copper with compression fitting on one side, and the new standard screw on connector on the other. That will let me extend the copper with the common braided water supply lines.

Is this the best solution?

 

[Bob_VT]

Re: Faucet connection problem.

That is common. Yes use the braided lines (I use the metal braided ones).