FD-11 lower unit

[57]

Just joined. Seems like a cool sight. Does anybody have a exploded view of an FD-11 lower unit? Just took it apart to change the seals and found an "extra" pin in gearcase. It's not the impeller pin or the larger prop pin. It is very small. Maybe 1/16" long and just a little larger in diameter. Any help would be great. Thanks.

 

[1946Zephyr]

Re: FD-11 lower unit

Here is a good place for an exploded view of your lower unit.

http://www.marineengine.com/parts/v...ntage-evinrude-johnson/377021/37702100001.htm

 

[F_R]

Re: FD-11 lower unit

One of the dowel pins that locate the prop shaft front & rear bearings? But it would be more than 1/16" long, unless you are saying that is how far they protrude, which is about right.

 

[samo_ott]

Re: FD-11 lower unit

Welcome to the forum. If you send me a private message (PM) with your request, I can send you the parts manual for the fd-11 which has the entire engine exploded.

 

[Chinewalker]

Re: FD-11 lower unit

I suppose it's possible the dowel pin sheared?

 

[57]

Re: FD-11 lower unit

Thanks for the parts diagram. It appears that all parts a accounted for. I actually measured my "extra" pin. It is .174" diameter ( just under 3/16" ) and .141" long. It looks to be the exact size of of one of the riveted pins on the shifter lever and pin assembly ( shifter fork ) that engage the cradle. Wonder if one broke off in the past and the lever was replaced and the pin was left behind?