Force 50hp can't find replacement HELP!!

[NTDaddy]

Looking to replace my prop on a 1989 force engine just curious if anyone out there has any ideas as the Michigan match prop does not have a proper match as mine has more of a box cut and the "replacement" for this type year and date and model has more of a "v" cut.

I can't seem to locate the exact one anywhere. Any ideas of what's going on, or a possible place to look located in north america I am located in Toronto

Thank you

 

[Frank Acampora]

Re: Force 50hp can't find replacement HELP!!

"box" and "Vee"? a photo would help.

 

[steelespike]

Re: Force 50hp can't find replacement HELP!!

If your looking at the images here at boats those are just generic prop images and don't necessarily resemble your prop.
I wouldn't be surprised that todays design may look nothing like a prop from 1989.
Is you're prop aluminum (not magnetic) or stainless steel (magnetic)?
As suggested pictures would help.

 

[riptorn]

Re: Force 50hp can't find replacement HELP!!

Good luck. Just try and find what pitch prop that would work for your boat and go with an after market. I have 2 original Force props with no info stamped on them what so ever aside from the Michigan stamped rubber packed spline.

 

[catfishcarl99]

Re: Force 50hp can't find replacement HELP!!

got your info. i have a 507y9b force 50 1989. what it on? size boat. mine is on a 17' fish and ski. a 13.5 pitch got me 23mph. a 11.5 pitch tonight got me 27. you need a 14 spline non exaust thru pin drive prop. michigan match numbers are as follows. 072133 13.5 pitch 072132 12.5 pitch
072131 11.5 pitch 072014 10 pitch these are 10 3/8" diam props cast alum with pressed rubber hubs. http://www.propline.com/Select-Boat.../Chrysler-Force-US-Marine-Outboards/20_60.htm
theres used one on ebay too. search for 10 3/8 propeller. then make sure to look if ya decide on one if it has 14 splines and or ask seller. got one there pretty cheap this spring.

 

[steelespike]

Re: Force 50hp can't find replacement HELP!!

As I understand it through hub props can be used on non through hub motors.
Frank has a number like that.Not sure if they use a pin drive.Don't know if normal through hub install procedure is required.
Perhaps a pm to Frank will help.