Getting 2001 Smartcraft into calibration mode

[flipflap]

Hi! I just bought a 2001 Mercury Optimax 150 with "smartcraft" (They actually dont say smartcraft, but look just the same)

I am unable to get these into cal1 or cal2 mode! I have tried holding the two normal buttons. And also any other combination I can think of.

Picture of the back of the gauge is here:

http://yfrog.com/mwbildej

Thanks

 

[jonesg]

Re: Getting 2001 Smartcraft into calibration mode

You should have bought an Evinrude Etec....

because this is the evinrude forum.

 

[flipflap]

Re: Getting 2001 Smartcraft into calibration mode

Haha, I have a e-tec 115ho as well. Therefore the confusion. Whoever has the power can delete this thread Thanks!