HELP!!!86 johnson 90 hp vro v4 impellar rebuild kit

[Bigcatdaddy7922]

Ok guys did the carb rebuild last night all new fuel lines from tank to carbs, new plugs, plug wires, now i have an impellar repair kit that i want to change out! Where do i start? things to watch for? Maybe some step by step directions! The weather is great here today so would luv to get this done today!Thanks in advance! Also does anyone have one of these, mine is broken and i would luv to fix while i am at it! Speed sensor! Transom mount i have a pic but it wouldnt load!

 

[ezeke]

Re: HELP!!!86 johnson 90 hp vro v4 impellar rebuild kit

......................Also does anyone have one of these, mine is broken and i would luv to fix while i am at it! Speed sensor! Transom mount i have a pic but it wouldnt load!

We have some here: http://www.iboats.com/Teleflex-Pitot-Tube/dm/*******.164296561--**********.280017756--view_id.40246

 

[ezeke]

Re: HELP!!!86 johnson 90 hp vro v4 impellar rebuild kit

You must remove seven bolts facing upward from the gearcase and disconnect the shift rod at the top under the carburetors.

The seven bolts are located as follows:

Two on each side;
One holding the trim tab;
One hidden above the trim tab;
One in front of the trim tab.

Mark the position of the trim tab so that you can replace it exactly as it was.

The shift rod is released by pulling the clip from the starboard side of the engine, and pushing the shift lever towards the center.

Try not to turn the shift rod during the whole process. It is threaded for adjusting up and down, but best left alone.

Note that among other housekeeping tasks, you might consider changing the inner gearcase to exhaust housing seal if it is worn. In any event, tape or glue the seal in place during reassembly so that it will not slip. After tightening, friction will hold it in place.

http://www.youtube.com/watch?v=Fj1c4oYpHAw