How to install fishing rod holders.

[steelhead79]

I need help installing fishing rod holders on my boat. I plan on trying my hand at trolling with dipsy divers or just flat line troling. I purchased two rod holders from Cabela's. These are the kind that can swivel in any direction. The mounting base has four holes in it for the screws. If I mount it to the boat, i am afraid that the fiberglass will break. Should I use a self tapping screw? Should I use a nut and a bolt? I will be fishing for walleye and steelhead on Lake Erie. Please help.

 

[Bob_VT]

Re: How to install fishing rod holders.

Welcome to iboats.<br /><br />Nut, bolt and a wide backing plate. You want to spread the load out to prevent fiberglass damage.<br /><br />Bob

 

[Barlow]

Re: How to install fishing rod holders.

yes, welcome steelhead79 <br /><br />I second Bob's post .. a couple scraps of plywood or aluminum sheet cut-offs for backing work great.<br /><br />I'll add fender washers, nylon lock nuts and a shot of silcone sealant to aid in keeping water from sneaking through the holes too .. don't need much of it.<br /><br />good luck

 

[down_time_1]

Re: How to install fishing rod holders.

Also use only s/s bolts ,washers and lock nuts and use a sharp drill bit and little pressure when drilling. hope this helps

 

[KM2]

Re: How to install fishing rod holders.

Is the base recessed in the the fiberglass or set on it? Mine from the factory and the additional ones I added set down thru the fiberglass and I just use ss self tapping. If the holder sits on top then I would bolt with backing.