bostonpilot
Cadet
- Joined
- Nov 22, 2007
- Messages
- 23
Hi All,
I have a Mariner 15 hp outboard (1991, OAxxxxxx series), and the kill switch at the end of the tiller has stopped working (tested with an ohm meter through the wiring). So, I was looking at it last night trying to figure out to get into the tiller in order to replace the switch.
I'm stumped - I can't figure out how to get in there and I'm at the point that it feels like I'm going to break something with all of the yanking and pulling I've been doing. Also, the exploded views that I've been looking at don't seem to yield much of an answer.
Any hints would be much appreciated.
Thanks!
I have a Mariner 15 hp outboard (1991, OAxxxxxx series), and the kill switch at the end of the tiller has stopped working (tested with an ohm meter through the wiring). So, I was looking at it last night trying to figure out to get into the tiller in order to replace the switch.
I'm stumped - I can't figure out how to get in there and I'm at the point that it feels like I'm going to break something with all of the yanking and pulling I've been doing. Also, the exploded views that I've been looking at don't seem to yield much of an answer.
Any hints would be much appreciated.
Thanks!