Manuals

[Kilifi]

Hi can anyone explain or show a diagram description of fuel hoses vacuum hoses primer hoses etc
Evinrude be90eledr
Kilifi

 

[kcassells]

Hi can anyone explain or show a diagram description of fuel hoses vacuum hoses primer hoses etc
Evinrude be90eledr
Kilifi

Just googled your engine and here are just a few things of many that showed up.

90Hp V4 1990 Evinrude GOOD??

Guys what's you opinions on this motor?Is there something I should look for?cheers

forums.iboats.com

1996 Evinrude 90hp E90ELEDR

So I just purchased a boat with the above mentioned engine. I've been in the process of replacing old worn out parts such as spark plug wires and spark plugs. The previous owner did not seem to know much about his motor. I'm trying to figure out which spark plug wires go where, 2 are shorter and...

forums.iboats.com

A manual is a necessity.

Evinrude Guides and Information | Evinrude US

Looking for Evinrude Owner's manuals? Looking for Evinrude Operator's guides?

www.evinrude.com

 

[Kilifi]

Thanks is there a search function on this forum for relevant service manual images to confirm the routing of the fuel recirculating system and vents ? Out of the manifold and crank case and how they all tie into the oil and fuel pumps
Thanks

 

[kcassells]

Thanks is there a search function on this forum for relevant service manual images to confirm the routing of the fuel recirculating system and vents ? Out of the manifold and crank case and how they all tie into the oil and fuel pumps
Thanks

No not really. Forum subject matter is too broad. Most boaters buy a manual
relative to their engine is all.
Yup you are correct, and pics/manuals will make you understand better. They will provide specific diagrams to your engine.
This is a generac pic.

I just finished a part of getting my engine up and running. Lots of good guys here to help. Mostly you need to do a lot of your own research and the forum/support adds to understanding your engine and repairs.

Johnson 1988 vro 225 hp fixing up a Frankenstein

I started working on this motor this summer. Hasn't been wet for about 5 years. Running high on idle @2500 rpm on hose. Chased out some air leaks etc. Pulled carbs, hoses, gaskets to manifold. The primer fittings below had no threads at all and were tapered as if "push in." The ports were not...

forums.iboats.com

 

[kcassells]

2 lines come of fuel solenoid that prime carbs
1 line comes off fuel solenoid that feeds carbs
1 line comes off fuel pump that feeds carbs
Each carb has a recirculation line that feeds unfired fuel in a loop from top to bottom sump.

 

[Scott Danforth]

You can get factory service manuals here:

Original outboard product and service manuals for Johnson, Evinrude, Gale, and OMC

Ken Cook Co. sells Original Product Literature Supporting 1996 and Older Outboard Marine Corporation Products, limited supply of original printings of Johnson, Evinrude, Gale, and OMC manuals are still available. On older literature, we may provide a machine copy reproduced from a master file...

outboardbooks.com