Rranger
Chief Petty Officer
- Joined
- May 18, 2009
- Messages
- 452
I have a older Sangster I’d like to put a engine pod on. I have a pod that was built for a houseboat that is 1/4” thick. I’m wondering if that is adequate to handle the torque. It would need some modification for use as a pod for my 125hp Mercury. I have a welder/fabricator lined up for the project, but I have concerns about it being only 1/4” plate. Anyone out there been through this or who has a custom made one that could tell me what thickness plate I need. Thank you.