97 hydrasport
Cadet
- Joined
- Dec 27, 2006
- Messages
- 18
Where would be a good starting point for the pin to stop the trim when it goes down for take off? My boat seems to be to low and I was just wanting some opions of where it should be to start. The boat is a 1997 hydrasport 175LS with a 150 intruder factory hung as far as I know and with no jack plate. It seems that the motor goes to far down and makes the carbs almost flood the engine, the pin was in the lowest hole when I got the boat. Any help will be great (THANKS)