primer bulbs that stay hard!

[Greg Lawrence]

where can i find one? i have two that are fairly new and they both leak air and go flat. you can hear it. i took off the metal bands and redid them TIGHT with tie straps and the still leak. i suppose there is no hope for them. ok im not running the motor or anything, im just pumping them filling up the bowls and it wont stay hard. i just rebuilt the carbs and the float levels are correct, and they have new seats needles. i can actually hear air bubbling into the bulbs at the bulbs.

 

[Greg Lawrence]

Re: primer bulbs that stay hard!

what primer bulb is the best one to get?

 

[S.T. Marine]

Re: primer bulbs that stay hard!

Sounds like a personal problem it wont stay hard........ I dont even want to know.... JK get a tempo primber blub from any boating store

 

[Greg Lawrence]

Re: primer bulbs that stay hard!

dood i got a attwood from wall mart a minute ago, im about to try it out, all the boating stores are shut down for the weekend, dang.

 

[Greg Lawrence]

Re: primer bulbs that stay hard!

ok i got it up and its hard, i got duelie fuel tanks baby!!! 24 gallons and 5 gallon gas can for reserve. this boat will get me to the wildlife refuge no problem. its alot better than drivin and launchin. ill just haul butt in the back way and be there before them other doods. going to tester outer the new setup tommorrow, gonna run from one end of the lake to the other non stop and back!!! fishing along the way of course. itll be about a 50-60 mile haul i calculate.. going to figure my mileage too. just wish i had a gps.