Prop drive pin stuck

[bonzoscott]

Anyone have any suggestions on how to remove a stuck drive pin? It appears to be a piece of a nail, rusted up really bad. It's so close to the thrust washer and I have tried sanding it down - penetrating oil etc. I don't know if I should apply any heat there as I've never been in a lower unit to that extent. I'm leaving it there for now but would be best to have it new.

 

[oldcatamount]

Re: Prop drive pin stuck

A small punch and a mallet might do it. Moderate heat won't hurt anything. Just a little and keep the (propane) torch moving.

 

[orbanp]

Re: Prop drive pin stuck

Do support the underside of the shaft with a piece of wood and some heavier weight underneath it (anvil), it will protect the shaft and the bearings while you are knocking out the remains of that shear pin.

Peter

 

[bonzoscott]

Re: Prop drive pin stuck

Good tips! I was concerned that heat would melt a seal. I'll give it a shot. Thanks...

 

[boobie]

Re: Prop drive pin stuck

Support the underside of the shaft real good, get the right size drift punch and give it one good wack with a hammer. Been there and done that.