mrtrimmier
Recruit
- Joined
- Feb 10, 2011
- Messages
- 5
I may have found a workable alternative to the manual trim cylinder assembly on the Johnson SPL's but would like to get a point to point measurement of the cylinder attachment points on the motor in the compressed and extended positons, and the base dimensions of the lower part of the assembly.
I'm looking to use the actuator from the bed tilt mechanism on a John Deere Gator (golf course vehicle) and would like this information from a felow owner as I'm nowhere near my boat until the end of June.
Regards
Mike Trimmier
FOB Salerno, Afghanistan
Port Royal SC