[FONT="]Just verifying on for my 1987 Johnson 90 reassembly. 21 27/32?
Yes, I've looked at the sticky.My engine year is not included. http://forums.iboats.com/forum/engi...ights-1973-thru-1981-50-235hp-by-obj?t=158088
No I don't have a factory OMC yet. The hunt continues.
I got this chart from Crowley Marine.
http://www.crowleymarine.com/support/tech_articles/johnson-evinrude-drive-shaft-installation.html
[/FONT]
[FONT="]*Add or subtract 5" for your application ( + or - 1/32" )[/FONT]
[FONT="]Everything else going smooth on the LU reassembly, even with a bum knee. [/FONT]
Yes, I've looked at the sticky.My engine year is not included. http://forums.iboats.com/forum/engi...ights-1973-thru-1981-50-235hp-by-obj?t=158088
No I don't have a factory OMC yet. The hunt continues.
I got this chart from Crowley Marine.
http://www.crowleymarine.com/support/tech_articles/johnson-evinrude-drive-shaft-installation.html
[/FONT]
| [h=3]Shift Rod Heights for 20" OMC-Bambardier Outboards*[/h] | ||
| CYL | YEAR | HEIGHT |
| 2 | 1976-1988 | 20-29/32" |
| 2 | 1989-UP | 21-15/16" |
| 3 | 1978-UP | 21-23/32" |
| V4 C/F | 1978-UP | 21-27/32" |
| V4 Looper-Small | 1986-1992 | 21-15/16" |
| V4 Looper-Big | 1993-2001 | 21-15/16" |
| V4 60° Carb | 1995-2003 | 21-1/4" |
| V6 C/F | 1979-1991 | 22-1/16" |
| V6 Looper | 1986-2003 | 21-15/16" |
| V6 60° | 1991-2003 | 21-1/4" |
| V6 60° - F.I. | 1998-2003 | 21-3/4" |
[FONT="]Everything else going smooth on the LU reassembly, even with a bum knee. [/FONT]