johnsons 4 cyl. J90PLSTC
Between wires Brown and Brown/White from the stator I have an ohm reading of 1.064 on the 2000 ohm setting. I'm assuming this means 1,064 which is way above what the directions say should be 450-600ohms.
Does anyone know this 4 cylinder system and know if this reading is bad? I'm not 100% sure if this is correct as the directions are for a 6 cyl but so far everything else matches ok. The volts are putting out ok though.
Between wires Brown and Brown/White from the stator I have an ohm reading of 1.064 on the 2000 ohm setting. I'm assuming this means 1,064 which is way above what the directions say should be 450-600ohms.
Does anyone know this 4 cylinder system and know if this reading is bad? I'm not 100% sure if this is correct as the directions are for a 6 cyl but so far everything else matches ok. The volts are putting out ok though.