Thru Hull Fuel Vent Fitting

[1985 Century Mustang]

While removing the old carpet from the Stern shelf above the engine room, I noticed my fuel vent fitting broke off the back of the hull inside the boat and I'm not sure what to order. Mine is about 1/2 inch wide or 30mm. It's a llittle short of a dime coin in width. I'm bad with fractions. Could it be a 1/2 inch? I noticed they don't list width of vent fittings in mm.

 

[Scott Danforth]

should be 5/8" vent fitting (16mm)

measure your hose. you most likely will need to either plumb in the P-trap or make sure your new vent has the p-trap.

 

[1985 Century Mustang]

should be 5/8" vent fitting (16mm)

measure your hose. you most likely will need to either plumb in the P-trap or make sure your new vent has the p-trap.

Mine doesn't have a P trap it's a straight fitting. I just remeasured it, it's 16 mm wide, your correct.

 

[1985 Century Mustang]

@Scott Danforth Is this the one I need?

https://www.amazon.com/Thru-Hull-Fuel-Chrome-Plated-Brass/dp/B0006ZCHGE/ref=mp_s_a_1_2?dib=eyJ2IjoiMSJ9.DGjd0H6qOfrt2btiToNkppSWl2bDQUIk9k9ztDkhOLAbhV0NW452YGqqO08iM-B1TxKTu9g_n5cmtB8NZQyBbYnax37lPm65__d9bJkEMCmEiUUd86T3quTXlZ5zMbOEypqY9tE8bWNYkdmHO1eU9-hcfbaeMkbobsv-Y8xl3NGQHMXalrINVcS1swlZoBEfUoPpFNShngjtwFRehxwBwg.A9YMDYnhs8_ZyPiSdoHnACp3vvVibF29KQ0IET19nqY&dib_tag=se&keywords=thru+hull+vent+5%2F8&qid=1716397718&sr=8-2