On my 1988 Evinrude 200hp VRO I hooked a timing light up to the #1 cylinder, top left port. The plastic/metal timing mark is directly in front of the engine as shown on the pic. Where the mark shows up on the flywheel when running is about 90* to the starboard side.(where I put the white mark on the one pic) I disconnected the timing and rod but even moving it by hand there is no way it will come close to the mark. Just in case I connected the light to the other 5 cylinders and they don't come close either. What am I doing wrong? Could someone have swapped on the wrong flywheel? The engine starts and runs out in neutral on land and in gear on land but not in gear on the water. Not even sure if that's a s.l.o.w or other problem but 1 step at a time.
